Mountain-off-road JKTFF User Manual

MOUNTAIN OFF ROAD ENTERPRISES, LLC. P.O. BOX 690 DELTA COLORADO 81416 970-625-0500 970-625-3747 FAX E-mail: [email protected] www.moun

Picture 23 Picture 27 Picture 25 Picture 24 Holes 1, Hole 2 Hole 3 Hole 4 Picture 26 Page 10 Rear mounting Bracket side view flush with inter wheel

Page 11 Push in all New plastic Buttons for final assembly Picture 30 Picture 31 Push in all New plastic Buttons for final assembly Picture 28 Pictu

TERMS-POLICIES: FIT and TOLERANCES: M.O.R.E.™ parts are the results of countless hours of research, testing, fitting and refining. Jeep® frames ha

BEFORE STARTING AND AFTER FENDERS HAVE FINAL PAINT OR POWDER COATING YOU MUST CLEAN AND WIPE CLEAN THE UNDERSIDE OF THE FENDER

Page 3 STEP 8: Remove entire fender components. ( see picture 11 ) STEP 9: Separate the three pieces of the factory fender and repeat step 1-8 on

STEP 18: Bolt on the front skirt mounting bracket through the factory hole (see picture 20 and 21). STEP 19: Bolting on the

Page 5 PICTURE 1 PICTURE 2 PICTURE 2a PICTURE 2b Remove

PICTURE 3 Page 6 PICTURE 4 PICTURE 5 PICTURE 6

Page 7 PICTURE 7 PICTURE 8 PICTURE 9 PICTURE 10

Page 8 PICTURE 11 PICTURE 12 PICTURE 13 PICTURE 14 PICTURE 15 ;PICTURE 16 Don’t trim metal. Trim plastic to fit tight against metal trim out piece.

Page 9 PICTURE 17 PICTURE 18 PICTURE 20 PICTURE 21 PICTURE 22 Existing factory hole for bolting on front skirt mounting bracket Drill 1/8” holes for